Using this industrial dispenser for wide adhesive rolls
Once the A690 automatic dispenser is installed, one of the following modes can be selected: automatic, semi-automatic and unwind mode.
Automatic mode:
First set the ON/OFF switch to ON.
Simply press the AUTO button on the device, then program the desired length using the CM or MM buttons. Then adjust the pressure of the roll according to the size and thickness of the adhesive reel, then recover the first strip of adhesive tape. The next one will be distributed automatically thanks to the M1000 reel sensor.
Semi-automatic mode:
This time set the ON/OFF switch to OFF.
Then press the AUTO button to unroll the tape to the length indicated on the digital panel. Press the AUTO button again for the next cut, and so on.
Unrolling:
For this mode, simply press the down arrow until the desired tape length is reached. Then press the CUT button on the device (illustrated with a pair of scissors) to cut the adhesive film.
Setting up and loading the roll
The installation of the M1000 is simple and very intuitive.
First, insure that the device is plugged into the mains. Then place the roll of adhesive around the hub and position it in the place provided for this purpose. Unroll the adhesive tape so that it is dispensed from above, then stick the adhesive strip onto the metal drive rollers. Finally press the ADVANCE button (down arrow), in order to unroll the adhesive through the cassette. The device is now ready for its first use.
Maintenance and cleaning
Proper safety precautions will need to be respected when servicing and cleaning the M1000 electronic dispenser. It is a cutting device whose parts can be dangerous once the device is opened. Maintenance must be performed by a professional. Avoid contact with blades and electrical systems.
Do not use detergents or other damp products to clean this device. It is therefore not recommended to clean the appliance with wipes. Rather opt for a dry cloth for cleaning.
In addition, it is preferable to remove the roll of adhesive when the automatic dispenser is idle for long periods ot time. This is to avoid the accumulation of glue residue on the blade. However, if this were to happen, carefully apply a bit of silicone oil to the guillotine-cut blade.